How much does a tumble dryer cost per load?

Find cycle energy

Use the energy label, manual or a suitable monitor for the actual programme. If a label gives kWh per 100 cycles, divide by 100. A rated heating-element wattage multiplied by the whole cycle can be misleading because heaters cycle.

Keep units attached to every number. Watts describe power, while kWh describe energy. The calculators apply the unit rate in pence per kWh and show pounds or pence without hiding the conversion.

Apply the tariff

Multiply kWh by pence per kWh, then divide by 100 for pounds. Keep standing charge separate. To estimate annual cost, multiply by the loads per week and 52.

Why loads differ

Fabric type, load weight, starting moisture, programme target, ambient temperature and sensor behaviour all matter. Heat-pump cycles can be longer but use a lower-temperature process.

Real use can vary by model, settings, condition and household routine. Test more than one reasonable scenario when a single assumption drives the answer. That range is more useful than reporting an over-precise total.

Worked annual example

At 2.5 kWh per load, four weekly cycles and 25p/kWh, annual energy is 2.5 × 4 × 52 = 520 kWh and cost is £130. This demonstrates the method, not the consumption of every dryer.

Reduce avoidable use

Use a suitable washing-machine spin, dry appropriate full loads without overfilling, separate different drying times and clean accessible filters as the manufacturer directs. Line drying may be suitable when conditions and household needs allow.

Applying this guide to your household

Start with the best source available: the product’s electrical input, an energy-label kWh value, the manual, or a safe representative measurement. Match the unit and period in the calculator. Enter your own tariff rather than a quoted national average, and keep the standing charge separate.

Check the live calculation breakdown after submitting. It repeats your inputs and shows how energy becomes cost. Save clearly labelled results to the basket, where you can change the tariff and compare each item’s share of the saved total. The basket does not send the data to this website.

If a comparison involves purchasing equipment, separate energy arithmetic from the financial decision. Purchase, delivery, installation, disposal, maintenance and ownership period can change payback. Repairability, suitability and safety are also relevant even though they are not converted into money here.

Checking whether the result is reasonable

Sense-check the order of magnitude before acting. A very high wattage used for only a few minutes may consume less energy than a modest load left running all day. Compare the calculated annual kWh with the period and frequency entered, and make sure pence were not entered as pounds or vice versa.

Run a low, central and high scenario when duration or cycling is uncertain. Record why each assumption was chosen. If a monitored figure is available, measure a complete representative programme or several ordinary days rather than selecting an unusually light session. Seasonal equipment needs observations from conditions similar to those being estimated.

Finally, distinguish the appliance estimate from the household bill. The bill can include every electrical load, standing charge, tariff changes, corrections and account adjustments. A difference does not automatically mean the formula is wrong; first compare the same time period, tariff basis and set of loads.

Limitations and assumptions

Results are estimates based on the information entered. Actual energy use can vary by appliance model, settings, temperature, cycling, condition and household behaviour. The calculation cannot predict future tariffs, repairs or behavioural changes. It estimates electricity only and does not include gas, water, detergent or the daily electricity standing charge unless a page explicitly says otherwise.

Examples explain the maths and are not claims about every appliance. This information is general, not electrical, installation, medical or financial advice. Follow manufacturer instructions and obtain appropriately qualified help where a safety-critical decision requires it.